Table of Contents
Advertisement
The ATTO FibreBridge 2400R/D is a 4-Gigabit Fibre Channel to SCSI bridge which can be embedded
in a variety of enclosures to integrate industry-leading performance and SAN capabilities into future
generation storage solutions.
The the 4-Gigabit FibreBridge 2400R/D includes
two independent 4-Gigabit Fibre Channel ports
and independent dual-stacked SCSI ports and is
available in an industry-standard 4U cPCI form
factor. The FibreBridge 2400 auto negotiates to 1,
2 and 4-Gigabit Fibre Channel.
Dimensions
Width: 17 inches
Length: 11 inches
Height: 1.7 inches (1U)
Weight: approximately 10 pounds
Cooling and airflow
Operating Temperature: 0-40° C external
Humidity: 10-90% non-condensing
Air enters from the front and is exhausted out the
connector side by a blower inside the enclosure
which provides 11 cubic feet per minute of
airflow. Ambient air near the inlets should not
exceed 40°C. The unit will automatically stop
operation if the temperature goes beyond this
threshold.
CAUTION
CAUTION
Do not block the enclosure's vents. The
FibreBridge will shut down if overheating
occurs.
Power
The power supply circuit is permanently mounted
within the enclosure and is not hot swappable. It
has one standard IEC320 power receptacle and
switch.
The universal power supply provides power for
the bridge board and cooling fan.
The power requirements of the ATTO
FibreBridge 2400R plus the power draw of the
other equipment in the rack must not overload the
supply circuit and/or wiring of the rack.
23
ATTO Technology Inc. FibreBridge Installation and Operation Manual
1.8 ATTO FibreBridge 2400R/D
Input voltage: 110/230V AC, with operating input
range of 90-132V AC or 175-264V AC, 47-63Hz,
single phase. The AC input range selection is
automatic with no manual or jumper switchover
required.
Power draw is 2 amps at 110V, 1.6 amps @ 90V
Fibre Channel port
The dual independent 4-Gigabit Fibre Channel
ports can connect the FibreBridge to either a
Fabric or Arbitrated Loop.
• Full support for full duplex FC data transfers, FC-
AL, PLDA and public loop login.
• Small Formfactor Pluggable (SFP) interface
• Auto negotiates with 1-, 2- and 4-Gb/sec.
devices
SCSI ports
The two SCSI ports connect storage devices into
the Fibre Channel Storage Area Network (SAN).
Each port is totally independent from the other.
The ports are Ultra 320 SCSI busses with VHDCI
connector, downward compatible with all forms
of single-ended SCSI and all previous SCSI
protocols.
Ethernet port
The 10/100 Base T Ethernet port is accessible
from the RJ45 connector. Local diagnostics are
supported through an integrated web server
(ATTO ExpressNAV), CLI, SNMP, Telnet and
FTP. Includes support for DHCP, Telnet, FTP,
ICMP and SNMP.
Serial interface
The 10-pin serial connector provides remote
monitoring and management through a command
line interface or the menu system
Advertisement
Table of Contents
