ATTO Technology FibreBridge 1180D Installation And Operation Manual page 72

Access to SCSI devices is via Fibre Port and Fibre LUN addresses mapped to SCSI bus, target and LUNs. CLI
commands are used to modify the mapping.
showing actual commands and their output to the Services port. Any commands which require Ethernet are not
available for ATTO FibreBridge 1180 models. Refer to the
which CLI commands apply to your model.
AddressMap
Specifies the address mapping state of the Fibre Channel
ports. AddressMap A denotes user-mapped LUN
addresses. AddressMap C denotes static LUN addresses.
Not available on the FibreBridge 2400.
Default: A
Set syntax: set AddressMap [ A |C ]
Requires a SaveConfiguration command
Get syntax: get AddressMap
AutoMap
Programmatically maps all currently operational SCSI
devices attached to the FibreBridge. Issue a SCSIPortList
CLI command before issuing an AutoMap command to
scan the bus for operational SCSI buses. Not available on
the FibreBridge 2400 if Logical Unit Addressing is
enabled.
Immediate:.AutoMap [fp]
DispFCPortDB
Used to display the contents of the specified FC port's
internal port database if the command FCInitiator has
been enabled. The database contains Fibre Channel
addressing information for each FC target device visible
to the FibreBridge.
Immediate: DispFCPortDB <fp>
FCConnMode
Controls/reports the connection mode the FibreBridge
uses when communication across a Fibre Channel
network, either to an arbitrated loop (FC-AL) when you
select loop mode, or point-to-point when you choose ptp.
Default: loop
Set syntax: set FCConnMode [loop | ptp]
Requires a SaveConfiguration command
Get syntax: get FCConnMode
61
ATTO Technology Inc. FibreBridge Installation and Operation Manual
2.5.9 Mapping commands
Appendix A
shows samples of the RouteXxxxx command interaction
CLI summary reference
FCHard
Used to enable or disable Fibre Channel hard address
assignment. Under soft addressing, the FibreBridge loop
address is assigned during loop initialization. Use
FCHardAddress (described below) if you enable hard
addressing.
Default: disabled
Set syntax: set FCHard [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get FCHard
FCHardAddress
Sets/displays the value used as the FC-AL hard address.
This hexadecimal value represents the address the
FibreBridge will try to use if hard addressing is enabled.
When an optional address is not present, the current value
is displayed. Choices are 0 through 125.
Default: 0x03
Set syntax: set FCHardAddress [ fp | [ address ]]
Requires a SaveConfiguration command
Get syntax: get FCHardAddress [fp]
FCPortFailover (FB 2400 only)
Controls the current operating mode of FC ports on the
FibreBridge 2400 only. When disabled, all FC ports are
active. When enabled, a designated FC port is marked as
reserved and becomes active only if a port fails. If a
failure occurs, the failover port takes on the identity of the
failed port. If enabled, all device maps on the designated
failover port will be deleted.
Default: disabled
Set syntax: set FCPortFailover [enabled | disabled]
Get syntax: get FCPortFailover
FCPortRecover (FB 2400 only)
Attempts to restore a bridge that has experienced a
failover to its pre-failover state.
Immediate: FCPortRecover
on page 41 to determine