Table of Contents
Advertisement
DisplayTraceLogFilter
Filters the display of data in the trace log. when in
DisplayTraceLog mode. If enabled for a particular
subsystem and level, that subsystem and level will be
masked when the command DisplayTraceLog is issued.
To display all values, type all all as parameters.
Default: disabled
Set syntax: set DisplayTraceLogFilter [FC | SCSI | ALL]
[fp | sb | ALL] [enabled | disabled]
Get syntax: get DisplayTraceLogFilter [FC | SCSI | ALL]
[fp | sb | ALL]
DumpEventLog
Dumps the contents of the entire event log to the current
CLI session without impact on the log itself (the log is not
cleared). No events will be recorded until the command
has been completed.
Immediate: DumpEventLog
DumpTraceLog
Dumps the contents of the entire trace log to an RS-232
or Telnet session over Ethernet without impact on the log
itself. (the log is not cleared). No events will be recorded
until the command has been completed.
Immediate: DumpTraceLog
EccLog
ECCLog contains the Error Correcting Code statistics
since the previous statistics were last cleared. The
maximum number of errors is 65535. Get form shows the
statistics. The set form sets the statistics to zero.
Set syntax: set EccLog clear
Get syntax: get EccLog
ErrorLog
Records various system errors to the errorlog. The set
version clears all previous entries.
Systems: 960, Static Memory, Synchronous DRAM,
ISP2200, Software
Set syntax: set ErrorLog clear
Get syntax: get ErrorLog
EventLog
When enabled, records various system errors to the
eventlog.
Default: enabled
Set syntax: set EventLog [enabled | disabled]
Get syntax: get EventLog
47
ATTO Technology Inc. FibreBridge Installation and Operation Manual
EventLogFilter
Filters the display of data for specific FibreBridge
subsystems when in EventLog mode. If enabled for a
particular subsystem and level, that subsystem and level
will be masked when the command EventLog is issued. To
display all values, type all all as parameters.
Subsystem entries:...........Log level entries:
ENET...............................INFO
XCOPY............................WARN
NVRAM............................CRIT
PERF..........................
....FAIL
ECC.............................
...ALL
GEN
Parity
Error
ALL
Default: all all disabled
Set syntax: set EventLogFilter [subsystem] [level]
[enabled | disabled]
Get syntax: get EventLogFilter [subsystem] [level]
FCPortList
Returns a list of available FC ports and their current
status. Valid status values are OK and Failed.
Immediate: FcPortList
FCSCSIBusyStatus
Specifies the SCSI status value returned when the
FibreBridge is unable to accept a SCSI command
because of a temporary lack of resources. Choices are
busy and qfull.
Default: busy
Set syntax: set FcSCSIBusyStatus [busy | qfull]
Requires a SaveConfiguration command
Get syntax: get FcSCSIBusyStatus
FCTargets
Obtains information about every FC target device visible
to a FibreBridge operating in initiator mode; devices may
be used as targets for initiator mode features such as
Extended Copy. The CLI command FcInitiator must be
enabled
Immediate: FcTargets
FCWWName
Reports the Word Wide Name (WWN) of the FC interface.
Each FC port has an individual and unique WWN. The
least significant 3 bytes of the WWN are used as the
Ethernet MAC address. The lower nibble of the highest
byte designates the port number.
Information only: get FcWWN [PortNumber]
Advertisement
Table of Contents
