ATTO Technology FibreBridge 1180D Installation And Operation Manual page 74

RouteOnline
Updates the status of the selected route to online if a
device is found or unavailable if a device is not found at
the SCSI address. If route is not currently mapped,
command results in an error message. Not available on
the FibreBridge 2400.
Set syntax: set RouteOnline [fp] [fl]
Get syntax: get RouteOnline [fp] [fl]
SCSIInitID
Specifies or reports the SCSI initiator ID on the specified
SCSI port as found in NVRAM. All maps coinciding with
the user-specified SCSIInitID must be set to offline and
will become invalid upon issuing this command. The set
command always modifies NVRAM, whether you use a
SaveConfiguration command or not.
Default: 7
Set syntax: set SCSIInitID [sb [0-15] ]
Get syntax: get SCSIInitID
63
ATTO Technology Inc. FibreBridge Installation and Operation Manual
SCSIInitID (FB 2400 only)
Specifies or reports the SCSI initiator ID on the specified
SCSI port as found in NVRAM. All maps coinciding with
the user-specified SCSIInitID will be destroyed after the
command is issued.
Default: 7
Set syntax: set SCSIInitID [sb [0-15] ]
Get syntax: get SCSII
SCSITargets
Returns a list of SCSI devices operational on the
referenced SCSI port. Also, for all models except the
FibreBridge 2400, updates the status of any online
maps/routes to unavailable if a device is not found or
online if a device is found.
Immediate: SCSITargets [sb]
ServicesLUN
Sets and displays the Services LUN for the specified Fibre
Channel port. Valid ServicesLUN entries are 0 through
(n-1) where n equals the number of Fibre Channel ports.
Valid entries for fl are 0-63. Any map coinciding with a
user-specified ServicesLUN must be set to offline before
trying to change a ServicesLUN.
Set syntax: set ServicesLUN [[fp] [fl] | [disabled] ]
Requires a SaveConfiguration command
Get syntax: get ServicesLUN [fp]