Table of Contents
Advertisement
The ATTO FibreBridge 2300R/D is a 2-Gigabit Fibre Channel to SCSI bridge for midrange high
performance, cost effective solutions in enterprise environments.
The FibreBridge 2300 includes one Fibre Channel
port and two SCSI ports. The desktop version
comes with attached feet for desktop use and
mounting brackets to convert to standard 19-inch
enclosures.
Dimensions
Width: 16.91 inches wide (42.95 cm)
Depth: 10 inches deep (25.4 cm)
Height: 1.72 inches high (4.32 cm) (1U)
Weight: approximately 10 pounds
Cooling and airflow
Operating Temperature: 5-40° C external
Humidity: 10-90% non-condensing
Air enters from the front and is exhausted out the
connector side by a blower inside the enclosure
which provides 11 cubic feet per minute of
airflow. Ambient air near the inlets should not
exceed 40°C. The unit will automatically stop
operation if the temperature goes beyond this
threshold.
CAUTION
CAUTION
Do not block the enclosure's vents. The
FibreBridge will shut down if overheating
occurs.
Power
The power supply circuit is permanently mounted
within the enclosure and is not hot swappable. It
has one standard IEC320 power receptacle and
switch.
The universal power supply provides power for
the bridge board and cooling fan.
The power requirements of the ATTO
FibreBridge 2300R plus the power draw of the
other equipment in the rack must not overload the
supply circuit and/or wiring of the rack.
15
ATTO Technology Inc. FibreBridge Installation and Operation Manual
1.5 ATTO FibreBridge 2300R/D
Input voltage: 110/230V AC, with operating input
range of 90-132V AC or 175-264V AC, 47-63Hz,
single phase. The AC input range selection is
automatic with no manual or jumper switchover
required.
Power draw is 2 amps at 110V, 1.6 amps @ 90V
Fibre Channel port
The single 2-Gigabit Fibre Channel port can
connect the FibreBridge to either a Fabric or
Arbitrated Loop.
• 2.125 Gigabit/sec.
• Class 2, Class 3 and ANSI Fibre Channel
specifications support
• PLDA, Public Loop Login (NL_port) and Fabric
Direct Connect (N_port) support
• Full Duplex transmission support
• Small Formfactor Pluggable (SFP) interface
• Backward compatible with 1.0625 gigabit/sec.
devices
SCSI ports
The two SCSI ports on the FibreBridge 2300
connect storage devices into the Fibre Channel
Storage Area Network (SAN). Each port is totally
independent from the other.
The ports are Ultra 3 LVD/SE SCSI busses with
68-pin "P" interface: 160 MB/sec. max
throughput, downward compatible with all forms
of single-ended SCSI.
Ethernet port
The 10/100 Base T Ethernet port assessable from
the RJ45 connector supports SNMP- and Telnet-
based monitoring and management through a
command line interface, menu system or ATTO
ExpressNAV.
Advertisement
Table of Contents
