ATTO Technology FibreBridge 1180D Installation And Operation Manual page 67

FcFairArb
Turns the FC Arbitrated Loop (FC-AL) arbitration
fairness on or off. When enabled, the FibreBridge follows
the arbitration fairness rules on the FC-AL.
Default: enabled
Set syntax: set FcFairArb [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get FcFairArb
FcFullDuplex
When enabled, allows full duplex FC communication
between the FibreBridge and other FC devices. Disable
FcFullDuplex results in half duplex mode.
Default: enabled
Set syntax: set FcFullDuplex [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get FcFullDuplex
FcHard
Used to enable or disable FC hard address assignment.
Under soft addressing, the FibreBridge loop address is
assigned during loop initialization. Use FcHardAddress
(described below) if you enable hard addressing.
Default: disabled
Set syntax: set FcHard [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get FcHard
FcHardAddress
Sets/displays the value used as the FC-AL hard address.
This hexadecimal value represents the address the
FibreBridge will try to use if hard addressing is enabled.
When an optional address is not present, the current value
is displayed. The valid range of values is 0 through 125.
Set syntax: set FcHard Address [fp | [address]]
Requires a SaveConfiguration command
Get syntax: get FcHardAddress [fp]
FcInitiator
Allows FibreBridge to operate as an initiator on the FC
network, an attribute required for features such as
Extended Copy to locate and send commands to FC
devices.
Set syntax: set FcInitiator [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get FcInitiator
Fcp2
Allows compliance with the FCP-2 FC specification.for
the FibreBridge 1290 only.
Default: disabled
Set syntax: set Fcp2 [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get Fcp2
Fcp2Conf
Requests FCP_CONF IUs when FCP-2 support is also
enabled for the FibreBridge 1290. The command is valid
only when FCP-2 support enabled.
Default: disabled
Set syntax: set Fcp2Conf [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get Fcp2Conf
Fcp2CRN
The FibreBridge 1290 will accept CRNs for precise
delivery of SCSI commands when FCP-2 support is also
enabled. Command is valid only when FCP-2 support
enabled.
Default: disabled
Set syntax: set Fcp2CRN [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get Fcp2CRN
Interfaces: FC commands
56