Table of Contents
Advertisement
• Backward compatible with 1.0625 GB/sec.
devices
Ethernet port
The 10/100 BaseT Ethernet port, accessible
from the RJ45 connector, located on the
board's faceplate, is implemented with an
Intel 82559ER controller. The Ethernet
interface supports SNMP- and Telnet-based
monitoring and management through a
command line interface or an integrated user
management console (ATTO ExpressNAV).
Serial interface
An RS-232 port accessible through an RJ11
connection on the front panel provides
support for remote monitoring and
management through a command line
interface.
LED indicators
Eight LEDs will be visible through the board
faceplate: two dual-stacked LEDs, two single
LEDs and two LEDs integrated into the RJ45
connector.
One set of dual-stacked LEDs will
FC Activity:
show Fibre Channel activity and Fibre Channel
link status. During very high activity, the LEDs
appear to be steadily lit.
SCSI 0 Activity, SCSI 1 Activity:
dual-stacked LEDs shows the activity on each
SCSI bus (numbered 0 and 1).
Installation instructions
1
Mount the FibreBridge in your device.
2
Connect a SCSI device to the FibreBridge.
Connect the Fibre Channel port to your
SAN.Connect the Ethernet cable from the Fibre
Bridge to your computer. Refer to
page 3.
3
Connect the power connector.
4
Apply power.
Ready/Fault LEDs
Serial port
Ethernet port
SCSI ports
Fibre Channel port
Board status:
Ready status while another LED will denote a
fault status.
LAN status:
RJ45 connector will indicate LAN link status; the
yellow LED will denote LAN activity.
Power:
and not visible through the faceplate indicates the
The other set of
board has power.
5
6
Cabling
on
7
8
Mounting hole
a single green LED will indicate
the green LED integrated into the
A surface-mounted LED on the board
Access FibreBridge Services using the
QuickNAV utility. Refer to
FibreBridge
on page 64.
Go to the ExpressNAV Restart page and
restart the FibreBridge.
Map your devices.Refer to
67.
Boot the computers on the SAN and check the
configuration. Refer to
Additional
configurations
on page 17
Installation: FibreBridge 2350C
Mounting hole
CPCI connector
Configuring the
Mapping
on page
22
Advertisement
Table of Contents
