Table of Contents
Advertisement
Installation instructions
1
Mount the FibreBridge in your device.
2
Connect a SCSI device to the FibreBridge.
Connect the Fibre Channel port to your
SAN.Connect the Ethernet cable from the Fibre
Bridge to your computer. Refer to
page 3.
3
Connect the power connector.
4
Apply power.
Exhibit 1.6-1 FibreBridge 2300E board layout
5
Access FibreBridge Services using the
QuickNAV utility. Refer to
FibreBridge
6
Go to the ExpressNAV Restart page and
restart the FibreBridge.
Cabling
on
7
Map your devices.Refer to
67.
8
Boot the computers on the SAN and check the
configuration. Refer to
configurations
Configuring the
on page 64.
Mapping
Additional
on page 17.
Installation: FibreBridge 2300E
on page
20
Advertisement
Table of Contents
