Table of Contents
Advertisement
Installation instructions
1
Physically place the FibreBridge in your device.
2
Connect a SCSI device to the FibreBridge.
Connect the Fibre Channel port to your
SAN.Connect the Ethernet cable from the Fibre
Bridge to your computer. Refer to
page 3.
3
Connect the power connector.
4
Apply power.
Exhibit 1.9-1 FibreBridge 2400C board layout
m o u n ting h o le
10 -p in
se ria l
h ea d e r
p ow e r L E D
m o u n ting h o le
E th e rne t
R e a d y/
F a u lt L E D
Cabling
on
F C a c tivity
p o rt
& link L E D s
5
Access FibreBridge Services using the
QuickNAV utility. Refer to
FibreBridge
on page 64.
6
Go to the ExpressNAV Restart page and
restart the FibreBridge.
7
Map your devices.Refer to
67.
8
Boot the computers on the SAN and check the
configuration. Refer to
configurations
on page 17.
F ib re
C ha n n e l
po rts
Configuring the
Mapping
on page
Additional
c P C I c o n ne c to r
m o u n tin g h o le
S C S I p o rts
S C S I
a c tivity
L E D s
Installation: FibreBridge 2400C
26
Advertisement
Table of Contents
