ATTO Technology FibreBridge 1180D Installation And Operation Manual page 65

SCSIPortSelTimeout
Indicates the time, in milliseconds, that the bridge waits
for a response from a SCSI device on the selected port
after a selection request. Setting a long selection time-out
value can result in the host generating system time-out.
Choices are 256, 128, 64, 32, 16, 8, 4, 2 or 1 milliseconds
Default: 256 milliseconds
Set syntax: set SCSIPortSelTimeout [sb [ 256 | 128 | 64 |
32 | 16 | 8 | 4 | 2 | 1] ]
Requires a SaveConfiguration command
Get syntax: get SCSIPortSelTimeout [sb]
SCSIPortSyncTransfer
Specifies whether synchronous SCSI transfers should be
negotiated with devices on the specified SCSI port.
Default: enabled
Set syntax: set SCSIPortSyncTransfer [[sb [enabled |
disabled] ]
Requires a SaveConfiguration command
Get syntax: get SCSIPortSyncTransfer [sb]
SCSIPortTaggedQueuing
Specifies whether tagged command queuing is allowed on
the SCSI port. Enabled allows tagged commands for
maximum performance
Default: enabled
Set syntax: set SCSIPortTaggedQueuing [sb [ enabled |
disabled ]]
Requires a SaveConfiguration command
Get syntax: get SCSIPortTaggedQueuing [sb]
SCSIPortTermination
FibreBridge 2400 only: Configures/reports the SCSI
internal termination of the SCSI port identified on the
FibreBridge 2400.
Default: enabled
Set syntax: set SCSIPortTermination [sb] [enabled |
disabled]
Requires a SaveConfiguration command
Get syntax: get SCSIPortTermination [sb]
SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be
negotiated. Enabled allows wide transfer negotiation
Default: enabled
Set syntax: set SCSIPortWideTransfer [sb [ enabled |
disabled ]]
Requires a SaveConfiguration command
Get syntax: get SCSIPortWideTransfer [sb]
SCSITermination
Configures/reports the SCSI internal termination of the
SCSI port identified.
Default: enabled
Set syntax: set SCSITermination [sb [enabled | disabled] ]
Requires a SaveConfiguration command
Get syntax: get SCSITermination [sb]
SpeedWrite
When enabled, improves the performance of FCP WRITE
commands to SCSI devices attached to the FibreBridge.
Specify SCSI bus (sb), target (st), LUN (sl) of a mapped
SCSI device or (all) for each currently mapped device
Set syntax: set SpeedWrite [sb st sl | all] [enabled |
disabled ]
Get syntax: get SpeedWrite [sb st sl | all]
SpeedWriteDefault
When enabled, SpeedWrite performance enhancement is
set as the default for any subsequent SCSI devices
mapped manually or via an AutoMap operation. If
disabled, the FibreBridge will not attempt SpeedWrite
performance enhancement to newly-mapped SCSI
devices.
Set syntax: set SpeedWriteDefault [enabled | disabled]
Get syntax: get SpeedWriteDefault
VirtualDriveResponse
Virtual Drive Response allows the FibreBridge to provide
proxy responses to SCSI INQUIRY and TEST UNIT
READY commands if a SCSI device is in a timeout or
busy. Host systems may then assign devices consistently
despite the device's state during execution of the SCSI
commands.
Default: disabled
Set syntax: set VirtualDriveResponse [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get VirtualDriveResponse
Interfaces: SCSI commands
54