ATTO Technology FibreBridge 1180D Installation And Operation Manual page 63

SCSIPortReset
Resets the specified SCSI bus.
Immediate: SCSIPortReset [sb]
SNTP
Sets/gets the SNTP setting. When enabled, the
FibreBridge will try, at reset and every 12 hours
thereafter, to contact a specified SNTP time server to
initialize/synchronize the time.
Default: enabled
Set syntax: set SNTP [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get SNTP
SNTPServer
Sets/gets the IP address of the SNTP time server. If the
FibreBridge is unable to contact the specified SNTP time
server within 30 seconds, the FibreBridge will try to
contact the first auxiliary SNTP time server. If not
successful, the FibreBridge will try to contact the second
auxiliary server. If not successful, the FibreBridge will
continue to keep time based on the most recent SNTP time
server, physical RTC or manual initialization or
synchronization
Auxiliary time servers included:
......129.6.15.28 (time-a.nist.gov)
......132.163.4.101 (time-a.timefreq.blrdoc.gov)
Default: 192.43.244.18 (time.nist.gov)
Set syntax: set SNTPServer xxx.xxx.xxx.xxx
Requires a SaveConfiguration command
Get syntax: get SNTPServer
SpeedWrite
SpeedWrite is a method to improve the performance of
FCP WRITE commands to SCSI devices attached to the
FibreBridge. You can specify the SCSI bus, target and
LUN of a mapped device or specify "all" to set or get the
state of all currently mapped SCSI devices.
Default: all disabled
Set syntax: set SpeedWrite [sb st sl | all] [enabled |
disabled]
Requires a SaveConfiguration command
Get syntax: get SpeedWrite [sb st sl | all]
SpeedWriteDefault
Specifies the state of SpeedWrite for any SCSI devices
mapped manually or via an AutoMap operation. If
enabled, any new SCSI device will use SpeedWrite
performance enhancement by default.
Default: disabled
Set syntax: set SpeedWriteDefault [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get SpeedWriteDefault
Time
Sets/displays the time in a 24-hour format. The default
time is 00:00:00 and is accurate until the FibreBridge is
reset or power-cycled when it returns to the default.
Default: 0:00:00
Set syntax: set Time [HH] : [MM] : [SS]
Requires a SaveConfiguration command
Get syntax: get Time
TimeZone
Sets/displays the time zone if SNTP is disabled. Setting
may be EST, CST, MST PST or a numerical offset from
GMT in the format +/- HH:MM. When SNTP is enabled,
applies the time zone setting to the time retrieved from a
specified SNTP time server to determine local time.
Default: EST
Set syntax: set TimeZone [EST | CST | MST | PST |
[+ / - HH : MM]]
Requires a SaveConfiguration command
Get syntax: get TimeZone
Zmodem
Allows transfer of a firmware image to or from the
FibreBridge using the ZMODEM file transfer protocol.
Available only through the RS232 interface.
Immediate: Zmodem [Send filename | Receive]
CAUTION CAUTION
After a firmware image is downloaded to
the FibreBridge, the image is placed into
flash memory. During this time (about 30
seconds), DO NOT remove power to the
FibreBridge or the flash may become
corrupted.
Interfaces: maintenance commands
52