Table of Contents
Advertisement
ATTO FibreBridge diagnostic commands help validate FibreBridge operation and diagnose/isolate FibreBridge
faults. Event logging is a mechanism for on-site observation of internal FibreBridge behavior such as tracing
SCSI commands received over the Fibre Channel from the host and return of data and status to the host. Any
commands which require Ethernet are not available for ATTO FibreBridge 1180 models. Refer to the
summary reference
on page 41 to determine which CLI commands apply to your model.
AutoLogSense
Controls Automatic LOG SENSE functions.
Default: disabled
Set syntax: set AutoLogSense [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get AutoLogSense
BridgeModel
Reports model information about the FibreBridge 2400.
For other Fibre Bridge models, refer to
FibreBridgeModel
on page 48.
Information only: get BridgeModel
BridgeName
Specifies the eight-character name assigned to the
FibreBridge 2400 used to identify individual FibreBridge
units. It is not the World Wide Name. The string is
alphanumeric, eight characters long,.For other Fibre
Bridge models, refer to
FibreBridgeName
Default: " "
Set syntax: set BridgeName [value]
Requires a SaveConfiguration command
Get syntax: get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries will
be recorded until ClearEventLog has completed.
Immediate: ClearEventLog
ClearTraceLog
Clears the contents of the trace log. No events will be
recorded until the command has been completed.
Immediate: ClearTraceLog
DispFcPortDB
Displays a table containing the WWNs of all known
devices in the FC network and their associated loop IDs.
This command is only valid when initiator mode is
enabled. See the CLI command FcInitiator.
Immediate: DispFcPortDB <fp>
2.5.3 Diagnostic commands
on page 48.
DisplayEventLog
Displays the most recent page of event log entries. Typing
a +, - or = causes the next, previous or same page of event
log entries to be displayed. No events will be recorded
until the command has been completed. Type <q> to
disable the command, begin new log entries, and return
to CLI.
Immediate: DisplayEventLog < + | - | = | q >
DisplayEventLogFilter
Filters the display of data for specific FibreBridge
subsystems when in DisplayEventLog mode. If enabled
for a particular subsystem and level, that subsystem and
level will be masked when the command
DisplayEventLog is issued.
Subsystem entries:...........Log level entries:
ENET...............................INFO
XCOPY............................WARN
NVRAM............................CRIT
PERF..........................
....FAIL
ECC.............................
...ALL
GEN
Parity
Error
ALL
Default: all all disabled
Set syntax: set DisplayEventLogFilter [subsystem] [level]
[enabled | disabled]
Get syntax: get DisplayEventLogFilter [subsystem] [level]
DisplayTraceLog
Displays the most recent page of trace log entries. Typing
a +, - or = causes the next, previous or same page of trace
log entries to be displayed. No events will be recorded
until the command has been completed. Type <q> to
disable the command, begin new log entries, and return
to CLI.
Immediate: DisplayTraceLog < + | - | = | q >
Interfaces: diagnostic commands
CLI
46
Advertisement
Table of Contents
