Table of Contents
Advertisement
2.5.8 Ethernet configuration commands
The Ethernet configuration commands configure the Ethernet and TCP/IP parameters. Any commands
which require Ethernet are not available for ATTO FibreBridge 1180 models. Refer to the
reference
on page 41 to determine which CLI commands apply to your model.
AutoLogSense
Controls Automatic LOG SENSE functions.
Default: disabled
Set syntax: set AutoLogSense [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get AutoLogSense
DhcpFixedDelay
Selects/displays the delay, in seconds, between DHCP
client request intervals. 0 time is typical. Choices are 0,
15 or 30 seconds
Default: 0 (no delay)
Set syntax: set DhcpFixedDelay [ 0 | 15 | 30 ]
Get syntax: get DhcpFixedDelay
EthernetSpeed
Sets/displays the current speed of the Ethernet
connection. Choices are 10, 100, and Auto.
Default: auto
Set syntax: set EthernetSpeed [ 10 | 100 | Auto ]
Requires a SaveConfiguration command
Get syntax: get EthernetSpeed
If auto enabled, value in parentheses indicates current
speed
Exit
Exits the current Ethernet telnet CLI session; it has no
effect if used during a serial or in-band CLI session.
Immediate command: Exit
59
ATTO Technology Inc. FibreBridge Installation and Operation Manual
IPAddress
Sets/displays the current FibreBridge IP address.If
IPDHCP is enabled (see below), get command reports
current IP address assigned by DHCP server. Setting this
value always modifies the internal NVRAM value of the
IP Address, whether or not a SaveConfiguration is
performed.
Default IP Address: 10.0.0.1
Set syntax: set IPAddress xxx.xxx.xxx.xxx
Get syntax: get IPAddress
IPDHCP
Selecting DHCP allows the FibreBridge to request an IP
address from the network. The network must have at least
one DHCP server.
Default: disabled
FibreBridge 2400 default: enabled
Set syntax: set IPDHCP [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get IPDHCP
IPGateway
Sets/displays the current gateway. If IPDHCP is enabled
(see above), get command reports current IP gateway
assigned by DHCP server. Setting this value always
modifies the internal NVRAM value of the IP Gateway,
whether or not a SaveConfiguration is performed. The IP
gateway address will be rejected if the FibreBridge IP
address is not in the same subnet as the gateway.
Default: 0.0.0.0
Set syntax: set IPGateway xxx.xxx.xxx.xxx
Get syntax: get IPGateway
IPSubnetMask
Sets/displays the current subnet mask. If IPDHCP is
enabled (see above), get command reports current subnet
mask assigned by DHCP server. Setting this value always
modifies the internal NVRAM value of the IP subnet mask
whether or not a SaveConfiguration is performed.
Default: 255.255.0.0
Set syntax: set IPSubnetMask xxx.xxx.xxx.xxx
Get syntax: get IPSubnetMask
CLI summary
Advertisement
Table of Contents
