Table of Contents
Advertisement
Password
Specifies password for all non-serial sessions: Telnet, ftp
and ExpressNAV user management console. You will be
prompted for the current password, to enter the new
password, and to confirm the new password. If local Echo
is enabled, password will echo all * characters. In
verbose mode only, CLI will request the password be re-
entered. When the password is all 0s, Telnet and ftp do not
validate the password and MD5 authentication is
disabled. Passwords are case sensitive and can be 1-32
characters long with no spaces.
Default: Password
Set syntax: set Password [ xxx ]
Requires a SaveConfiguration command
Ping
Sends an ICMP echo request to the specified host.
Immediate command: ping [ MPn] [xxx.xxx.xxx.xxx]
<count <size>>
ReadOnlyPassword (FB 2400 only)
Specifies password for all non-serial sessions: Telnet, ftp
and ExpressNAV user management console. An empty
password can be configured by not specifying one.
Default: Password
Set syntax: set ReadOnlyPassword [ xxx ]
Requires a SaveConfiguration command
ReadOnlyUsername (FB 2400 only)
Specifies username for all Telnet, ftp and ExpressNAV
user management console sessions. Username is case
insensitive, 1-32 characters, no spaces.
Default: User
Set syntax: set ReadOnlyUsername [username]
Requires a SaveConfiguration command
Get syntax: get ReadOnlyUsername
SNMPDumpMIB
Dumps the contests of the ATTO custom MIB to the
current CLI session.
Immediate command: SNMPDumpMIB
SNMPTrapAddress
Sets/displays the IP trap addresses and levels.
Index: value between 1 and 6
IP Address: standard IP address
Trap Level: severity required for an event to trigger a trap:
...None: no traps will be sent to the address
...ALL: all triggering events will be sent
...Informational: a trap will be issued to the given address
...Warning: warning and critical events will be sent
...Critical: only critical events will trigger a trap
Set syntax: set SNMPTrapAddress [Index] [ IPAddress ]
[level]
Get syntax: get SNMPTrapAddress
SNMPTraps
Enables/disables SNMP trap functions.
Default: disabled
Set syntax: set SNMPTraps [enabled | disabled]
Get syntax: get SNMPTraps
SNMPExtendedTraps
Enables/disables extended traps such as device transition
and device error. Not available for the FibreBridge 2400.
Default: disabled
Set syntax: set SNMPExtendedTraps [enabled|disabled]
Get syntax: get SNMPExtendedTraps
Username
Specifies username for all Telnet, ftp and ExpressNAV
user management console sessions. Username is case
insensitive, 1-32 characters, no spaces
Default: root
Set syntax: set Username [username]
Requires a SaveConfiguration command
Get syntax: get Username
Interfaces: Ethernet commands
60
Advertisement
Table of Contents
