Table of Contents
Advertisement
The ATTO FibreBridge 2400C is a 4-Gigabit Fibre Channel to SCSI bridge which can be embedded in
a variety of enclosures to integrate industry-leading performance and SAN capabilities into future
generation storage solutions.
The FibreBridge 2400C includes two independent 4-
Gigabit Fibre Channel ports and independent dual-
stacked SCSI ports available in an industry-standard
4U cPCI form factor. The FibreBridge 2400 auto
negotiates to 1- 2- and 4-Gigabit Fibre Channel.
Board dimensions
Width: 6.1939 inches
Length: 6.299 inches
Height of tallest component: .545 inches
Cooling and airflow
Operating Temperature: 0-40° C
Humidity: 10-90% non-condensing
Power
The drive power connector (18 watts) allows the
FibreBridge 2400C to draw power from a standard
12/5V drive.
Fibre Channel port
The dual independent 4-Gigabit Fibre Channel ports
can connect the FibreBridge to either a Fabric or
Arbitrated Loop.
• Full support for full duplex FC data transfers, FC-
AL, PLDA and public loop login.
• Small Formfactor Pluggable (SFP)
interface
• Auto negotiates with 1-, 2- and 4-Gb/sec.
devices
SCSI ports
The two SCSI ports connect storage devices into
the Fibre Channel Storage Area Network (SAN).
Each port is totally independent from the other.
The ports are Ultra 320 SCSI busses with
VHDCI connectors, downward compatible with
all forms of single-ended SCSI and all previous
SCSI protocols.
25
ATTO Technology Inc. FibreBridge Installation and Operation Manual
1.9 ATTO FibreBridge 2400C
Ethernet port
The 10/100 Base T Ethernet port is accessible from the
RJ45 connector. Local diagnostics are supported
through an integrated web server, ATTO ExpressNAV,
the preferred management tool. Includes support for
DHCP, Telnet, FTP, ICMP and SNMP.
Serial interface
The 10-pin serial connector provides remote
monitoring and management through a command line
interface.
LED indicators
indicates if power is available from the
Power:
supply.
FC 1 and FC 2 Activity:
activity on the Fibre Channel ports (numbered 1 and
2). During very high activity, the LEDs appear to be
steadily lit.
SCSI 1 Activity, SCSI 2 Activity:
its own LED to show activity on that bus (numbered 1
and 2).
lights after power has been applied indicating
Ready:
the FibreBridge is ready to operate.
10-pin serial header
power LED
Ready/Fault LED
Ethernet port
FC activity & link LEDs
Fibre Channel ports
SCSI ports
SCSI activity LEDs
LEDs blink to show
each SCSI bus has
mounting hole
cPCI connector
Advertisement
Table of Contents
