Table of Contents
Advertisement
The CLI commands outlined in this chapter get information or perform functions which are used in a
variety of situations with the FibreBridge.
CLI commands are case insensitive (upper and
lower case allowed anywhere).
FibreBridgeName
Specifies the eight-character name assigned to the FibreBridge used to identify individual FibreBridge units. It is not the World Wide Name (WWN).
Actions: set FibreBridge Name [value]
SaveConfiguration
Info
Displays version numbers and other production information for key components within the FibreBridge
Action: none
Help
Displays a list of available commands. If command name is specified, displays detailed command-specific information.
Action: none
Reserve
Reservation of the FibreBridge is implicit: once the configuration image is changed by any user of services, the FibreBridge becomes RESERVED.
Executing a SaveConfiguration, RestoreConfiguration or FcRestart RELEASES the FibreBridge so that other services users may access it.
Limits: When FibreBridge services interface is RESERVED, set commands from other users are unavailable.
At least one interface must always have access to the FibreBridge.
Action: Reserve
Return: [enabled | disabled]
RestoreConfiguration
Restores configuration to either the default configuration or the configuration last saved into non-volatile memory. The saved option will undo any
changes made since the last save.
Actions: RestoreConfiguration [Default | Saved]
SaveConfiguration
Many commands require a SaveConfiguration command to be executed. This will be indicated by the return Ready. *. When you invoke
SaveConfiguration, the current configuration is permanently saved in the FibreBridge and the new configuration becomes the active configuration.
If a firmware restart is required to make the requested change permanent, you will see a prompt asking you to confirm the restart. You can override
this request by indicating the override value on the command line. You may make several changes through commands and SaveConfiguration before
implementing the restart, but once you have restarted the FibreBridge, all the command changes created before the restart and save will be
implemented. If you select the restart option, the FibreBridge will execute its complete start up cycle.
Limits: Restart or no Restart parameter is optional
Actions: SaveConfiguration <Restart| NoRestart>
Returns: [Configuration saved |
Restart is necessary...
Do you wish to restart (y/n)? y
Restarting...]
VerboseMode
Specifies the detail of feedback for the command line interface. Disabling this option removes parameter names from action commands and removes
descriptions from information commands.
Limits: enabled or disabled
Actions: set VerboseMode [enabled | disabled]
15 ATTO Technology FibreBridge 1190E Installation and Operation Manual
7.1.1 General use commands
Commands generally follow a standard format:
[Get | Set] Command [Parameter 1 | Parameter 2]
followed by the return or enter key.
Information: get FibreBridgeName
Information: Info
Information: Help [command name]
Information: none
Information: none
Information: none
Default: enabled (returns have parameter information)
Information: get VerboseMode
Advertisement
Table of Contents
