Table of Contents
Advertisement
FibreBridgeModel
Reports model information about a specific FibreBridge
Information only: get FibreBridgeModel
FibreBridgeName
Specifies the eight-character name assigned to the
FibreBridge used to identify individual FibreBridge
units. It is not the World Wide Name. The string is
alphanumeric, eight characters long,.
Set syntax: set FibreBridgeName [value]
Requires a SaveConfiguration command
Get syntax: get FibreBridgeName
FixedLengthReqSense
Specifies that the FibreBridge will pad the number of
autosense data returned as a result of a CHECK
CONDITION to a mod 4 length.
Default: disabled
Set syntax: set FixedLengthReqSense [ enabled |
disabled]
Get syntax: get FixedLengthReqSense
Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Immediate: Help [command name]
IdentifyBridge
Enabling this option causes the Ready LED on the front
panel of the FibreBridge to blink until the parameter is
disabled.
Set syntax: set IdentifyBridge [enabled | disabled]
Get syntax: get IdentifyBridge
IdentifyFibreBridge
Enabling this option causes the Ready LED on the front
panel of the FibreBridge to blink until the parameter is
disabled.
Set syntax: set IdentifyFibreBridge [enabled | disabled]
Get syntax: get IdentifyFibreBridge
Info
Displays version numbers and other production
information for key components within the FibreBridge
Immediate: Info
ParityLog
Contains the parity error statistics for the FibreBridge
since the statistics were last cleared. The set form sets the
statistics to zero. Choice 65,535 maximum number of
errors
Set syntax: set ParityLog clear
Get syntax: get ParityLog
Performance
Returns the performance data for the FC port you specify.
Data includes the average rate (MB per sec.) and number
of I/Os measured over the previous sampling period
where a sampling period is approximately one second.
Requesting performance data for an FC port which has
been disabled or has failed will result in the display of an
error message ("ERROR Disabled Fibre Channel port"
or "ERROR Failed Fibre Channel port"). Reported
performance may be affected by FC port and SCSI bus
availability and saturation, SCSI device speeds and
overall system use.
Information only: get Performance <fp>
SCSIPortList
Returns a list of available SCSI ports and their current
status. Valid status values are OK and Failed.
Immediate: SCSIPortList
SCSITargets
Returns a list of SCSI devices operational on the
referenced SCSI port with SCSI target number, SCSI LUN
number, device type, vendor ID, product ID, revision and
serial number. Also for all models except the FibreBridge
2400, updates the status of any 'online' maps/routes to
'unavailable' if a device is not found or 'online' if a
device is found.
Information only: SCSITargets [sb]
SerialNumber
Reports the FibreBridge serial number which is unique
for each FibreBridge. The serial number tracks the board
throughout its life and should not be changed for any
reason. Set form requires operator privileges.
Information only: get SerialNumber
SNMPDumpMIB
Dumps the contents of the private ATTO FibreBridge
SNMP MIB to the current CLI session.Contact your
system administrator for help.
Immediate command: SNMPDumpMIB
Interfaces: diagnostic commands
48
Advertisement
Table of Contents
