General Use Commands; Help; Password; Readonlypassword - ATTO Technology 1500D Installation And Operation Manual

These CLI commands are used in a variety of situations

Help

Lists available commands. If command name is specified,
displays detailed command-specific information.
Help [command name]

Password

Specifies a password for all sessions: Telnet, FTP and
ExpressNAV web-based interface. You are prompted for
the current password, to enter the new password, and to
confirm the new password. Passwords are case sensitive,
0-32 characters with no spaces.An empty password can
be configured by entering the Password confirmation
prompts with no parameters. The command
RestoreConfiguration default sets the password to its
default value.
Default: Password
set Password
Requires a SaveConfiguration command

ReadOnlyPassword

Specifies a read only password for all sessions: Telnet,
FTP and ExpressNAV web-based interface. You are
prompted for the current password, to enter the new
password, and to confirm the new password. Passwords
are case sensitive, 0-32 characters with no spaces. An
empty password can be configured by entering the
Password confirmation prompts with no parameters. The
command RestoreConfiguration default sets the
password to its default value.
Default: Password
set ReadOnlyPassword
Requires a SaveConfiguration command

ReadOnlyUsername

Specifies a read only user name for all Telnet, FTP and
ExpressNAV web server sessions. Username is case
insensitive, 1-32 characters with no spaces.
Default: user
set ReadOnlyUsername [username]
39
ATTO Technology Inc. iPBridge Installation and Operation Manual

7.1.2 General use commands

Requires a SaveConfiguration command

RestoreConfiguration

Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option undoes any changes made since the last
save.
RestoreConfiguration [Default | Saved]

SaveConfiguration

Many commands require a SaveConfiguration
command indicated by the return Ready. *.
When you invoke SaveConfiguration, the current
configuration is permanently saved in the iPBridge and
the new configuration becomes the active configuration.
If a firmware restart is required to make the requested
change permanent, you see a prompt asking you to
confirm the restart. You can override this request by
indicating the override value on the command line.
You may make several changes through commands and
SaveConfiguration before implementing the restart,
but once you have restarted the iPBridge, all the
command changes created before the restart and save are
implemented. If you select the restart option, the iPBridge
performs its complete start up cycle.
Restart or no Restart parameter is optional
SaveConfiguration < Restart | NoRestart >

Username

Specifies a user name for all Telnet, FTP and
ExpressNAV web server sessions. Username is case
insensitive, 1-32 characters with no spaces. You must be
using the Admin password to change Username.
Default: root
set Username [username]
Requires entering a password
Requires a SaveConfiguration command
get Username