Table of Contents
Advertisement
FCPortFailover
Controls the current operating mode of FC ports on the
bridge. When disabled, all FC ports are active. When
enabled, a designated FC port is marked as reserved and
becomes active only if a port fails. If a failure occurs, the
failover port takes on the identity of the failed port. If
enabled, all device maps on the designated failover port
will be deleted.
Default: disabled
Set syntax: set FCPortFailover [enabled | disabled]
Get syntax: get FCPortFailover
FcPortList
Returns a list of available FC ports and their current
status. Valid status values are OK and Failed for all
FibreBridge models, and Reserved for the FibreBridge
2400.
Immediate: FcPortList
FCPortRecover
Attempts to restore a bridge that has experienced a
failover to its pre-failover state.
Immediate: FCPortRecover
FCSCSIBusyStatus
Specifies the SCSI status value returned when the
FibreBridge is unable to accept a SCSI command
because of a temporary lack of resources. Choices are
busy and queue full.
Default: busy
Set syntax: set FcSCSIBusyStatus [busy | qfull]
Requires a SaveConfiguration command
Get syntax: get FcSCSIBusyStatus
FcTargets
Obtains information about every FC target device visible
to a FibreBridge operating in initiator mode; devices may
be used as targets for initiator mode features such as
Extended Copy.
Get syntax: FcTargets
57
ATTO Technology Inc. FibreBridge Installation and Operation Manual
FcWWName
Reports the Word Wide Name (WWN) of the FC interface.
Each FC port has an individual and unique WWN. The
least significant 6 bits of the WWN are used as the
Ethernet MAC address. Fabric and loop operations are
unpredictable if duplicate WWNs are assigned.
Information only: get FcWWN [PortNumber]
FibreBridgeTargetLUN
Specifies the soft target LUN(s) to be used by the
FibreBridge when addressed by the host as a SCSI device.
Any map coinciding with the user-specified FcTargets
LUN must first be set to offline before trying to change it.
This map will be destroyed upon power-cycling the FB.
Disabling a FibreBridgeTargetLUN for a particular FC
port will destroy the map for that port. The get form
reports all FB Target LUNs currently NOT disabled.
Specifying a port returns the status of that port. Valid
entries [fl] are 0 to 63.
Set syntax: set FibreBridgeTargetLUN [[fp] [fl] | [disabled]]
Requires a SaveConfiguration command
Get syntax: get FibreBRidgeTargetLUN [fp]
Performance
Returns the performance data for the FC port you specify.
Data includes the average rate (MB per sec.) and number
of I/Os measured over the previous sampling period. A
FC port which has been disabled or has failed will prompt
an error message. Reported performance may be affected
by FC port and SCSI bus availability and saturation,
SCSI device speeds and overall system use.
Information only: get Performance [fp]
ServicesLUN
Sets and displays the Services LUN for the specified FC
port. Valid ServicesLUN entries are 0 through (n-1)
where n equals the number of Fibre Channel ports. Valid
entries for fl are 0-63. Any map coinciding with a user-
specified ServicesLUN must be set to offline before trying
to change a ServicesLUN.
Default: 0x08
Set syntax: set ServicesLUN [ [ fp] [ fl ] | [disabled] ]
Requires a SaveConfiguration command
Get syntax: get ServicesLUN [fp]
Advertisement
Table of Contents
