btsr SMART MATRIX WARP Operating Manual page 91

Other factors that may affect the control
DELAY [s]
Is the sensor waiting time before starting the control process, namely the time needed to the machine to
reach the set speed (Programmable).
TENS [ABS/REL]
It defines the sensor operating mode as regards the calculation of min/max threshold and peak values with
reference to the yarn tension
ABS:
ABSOLUTE
(TENS) defined by the operator during the article programming phase (NEW or MODIFY)
which applies to all sensors to which that article has been loaded (LOAD).
The
TENS H
respect to the
processing cycle
REL:
RELATIVE
by each sensor during the
processing cycle. Even in this case the
be constant values, but referred to a specific value (relative) to each sensor.
KEY [LOCK/UNLOCK]
It defines the Touch Light button operating mode:
LOCK: The button is enabled for the Automatic Numbering procedure only.
UNLOCK: The button is enabled not only for the Automatic Numbering procedure, but also for reset in
case of alarm.
MODE [MONITOR-CONTROL]
It defines the operating mode of the system when a defect is detected
MONITOR: No Failure
TENS H failure
PEAK H failure
TENS L failure
PEAK L failure
NOYARN failure
In Monitor mode, as soon as the failure condition disappears, the sensor automatically
resumes the normal operation and turns on the green LED.
CONTROL: No Failure
TENS H failure
PEAK H failure
TENS L failure
PEAK L failure
NOYARN failure
In Control mode, the failure condition must be reset either through the touch light or through
the ENABLE input (see Note on next page).
.
mode – all calculations are carried out according to a constant reference value
, , ,
TENS L PEAK H PEAK L
reference and will always remain unchanged throughout the entire yarn
TENS
mode – All calculations are carried out according to a reference value self-learned
LEARN
= Green LED lit
= 1 flash, red LED
= 2 flashes, red LED
= 1 flash, red + green LEDs
= 2 flashes, red + green LEDs
= continuous flashing, red LED + STOP output activation
= Green LED lit
= 1 flash, red LED + STOP output activation
= 2 flashes, red LED + STOP output activation
= 1 flash, red + green LEDs + STOP output activation
= 2 flashes, red + green LEDs + STOP output activation
= continuous flashing, red LED + STOP output activation
SMART MATRIX
and values too will then be constant values with
NOYARN
phase, that will remain constant throughout the entire yarn
, ,
TENS H TENS L PEAK H
TS5/TS7 Sensor Features
, and values will
PEAK L NOYARN
- 3-11 -