btsr SMART MATRIX WARP Operating Manual page 36

Hide thumbs Also See for SMART MATRIX WARP:
Table of Contents

Advertisement

Example with CREEL LEVELS parameter = 02 (2 creel levels)
Sensor Configuration and Numbering
To return to CONTROL status.
Point and select
CREEL
Set the number of
÷ 04; on this example
Point and select
CREELS PER LEVEL
Set the
CREELS PER LEVEL
Point and select
CREELS PRIORITY
Choose the desired priority (Rows, Columns, Bars)*
* The
ENDS
option refers to a special configuration that
cannot be used in a general way
SAVE
to save the settings,
previous screen without saving,
menu
If
CREEL LEVELS
parameter is different from OFF, then
the creels are identified with a number and a letter; the
number corresponds to
identifies in sequence the creels. On this example, two
levels with two creels per level have been set, therefore the
creel numbers will be: 1A, 1B, 2A and 2B.
Point
CREEL 1A
Select
Col
field.
Set the number of Columns for Creel 1A.
Select the
Row
field
Set the number of Rows of Creel 1A.
Point
CREEL 1B
and so on for all the used creels.
Once you have configured all the creels.
IDENTIFY
to start the sensor identification.
SMART MATRIX
LEVELS.
CREEL LEVELS
[Allowed values 02
CREEL LEVELS
= 02].
[Allowed values: 01 ÷ 16]
BACK
to go back to the
EXIT
to go back to the
CREEL
LEVEL, while the letter
- 2-14 -

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMART MATRIX WARP and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF