Status Monitoring - Jetter JetMove D203 User Manual

JetMove D203
8
The amplifier LEDs indicate the operating status of the digital servo amplifier.
VCC1 L 1
L 3 L 2
Jetter AG

Status Monitoring

LED Color
VCC1 Green
L1 Yellow
L2 Yellow
L3 Yellow
Notice!
The 7-segment display of the output stage indicates the operating and fault
conditions of the digital servo amplifier JetMove D203. The various display
modes are set by the Motion Setup. Mode 0 (default) is used for normal operation
and mode 1 for commissioning.
JetMove D203 - Seven-Segment Display
Mode 0: Normal Operation
Display Status
0 NOT READY TO BE
SWITCHED ON
1 SWITCH-ON INHIBIT
2 READY TO BE SWITCHED
ON
3 SWITCHED ON
4 OPERATION_ENABLED
LEDs at JetMove D203
Status
is lit Logic module voltage is OK
is lit Axis is standing still (speed = 0)
is lit A voltage of 24 V is applied to the input of
the positive limit switch (LIMIT+).
is lit A voltage of 24 V is applied to the input of
the negative limit switch (LIMIT-).
Initialization of amplifier functions
Initialization completed. Safe state. Is
achieved after initialising and after
acknowledging errors.
The drive controller can be switched
on.
Drive controller has been disabled by
software command.
The drive controller can be switched
on.
DC link monitoring is activated.
The drive controller has been
enabled.
Description
Description
79