Hiperface Connection; Specifications; Hiperface Cable With Mating Connector - Jetter JetMove D203 User Manual

JetMove D203
7.4
7.4.1
Specification of the connector for terminal X71 / X81 (ENCODER)
•
•
Specification of HIPERFACE cable
•
•
•
•
•
•
7.4.2
Jetter AG

HIPERFACE Connection

Specifications

15-pin male SUB-D connector
Metallized enclosure
Cable size:
Minimum 4 * 2 * 0.14 mm² + 2 * 0.5 mm² (AWG 26(8) + AWG 20(2)).
2 * 0.5 mm² (AWG 20(2)) must be used for power supply and for GND.
Twisted-pair cables shielded with the all-over shield must be used;
The signal lines must also be twisted in pairs:
Sine + and reference sine
Cosine + and reference cosine
DATA - and DATA +
0 V and voltage supply
The shield must be connected to the connector housings at both ends of the cable
with the greatest possible surface area.
Material: Copper
Temperature class: 60 °C
Maximum cable length: 50 m

HIPERFACE cable with mating connector

INFO
The resolver respectively HIPERFACE mating connector can be ordered from
Jetter AG by specifying item number 15100069.
The complete resolver cable connecting the servo amplifier series JetMove D203
and synchronous servo motors can be ordered from Jetter AG by specifying the
following item number (KAY) and the respective cable length in cm:
KAY_0923-xxxx For the servo amplifier series JetMove D203
7.4 HIPERFACE Connection
59