JetMove D203
5.2
There are three ways of motor protection:
5.2.1
The servo amplifier JetMove D203 can read out and process four different motor
temperature sensors:
The thermal sensors must be designed for being connected with 10 V at 10 mA.
Jetter AG
Compatible Synchronous Servo Motors
Motor types
INFO
In case you intend to use motors other than the above mentioned types, please
contact Jetter AG.
Motor Protection
Thermal sensor integrated in the motor
Sensor type
Type of sensor signal evaluation
Temperature
Go-no-go decision
switch
Error detection at maximum motor temperature
KTY84-130
Temperature is measured in °C
The warning threshold can be set
Error detection at maximum motor temperature
KTY83-110
Temperature is measured in °C
The warning threshold can be set
Error detection at maximum motor temperature
PTC
Go-no-go decision
Error detection at maximum motor temperature
Nominal addressing resistance at ϑ
•
4000
•
The resistance must be lower than 500 at temperatures
smaller than ϑ
Jetter motors of the JHN, JHQ, and Jl series
with 2-cable technology.
Please also refer to the User Manual of the
motors or contact the sales department of
Jetter AG.
Ω
within +/- 5 K.
Ω
- 20 K
NAT
5.2 Motor Protection
Ω
between 550
and
NAT
43