Status Monitoring - Jetter JM-206-230 User Manual

JetMove 206B-230
8
The output stage LEDs indicate the operating status of the digital servo amplifier.
Jetter AG

Status Monitoring

JetMove 206B-230 - LEDs
LED
5V
L1
L2
L3
Note!
The seven-segment display of the output stage indicates the operating and fault
conditions of the digital servo amplifier JetMove 206B-230. The various display
modes are set by the Motion Setup. Mode 0 (default) is used for normal operation
and mode 1 for commissioning.
JetMove 206B-230 - Seven-Segment Display
Mode 0: Normal Operation
Display
0 NOT READY TO BE
SWITCHED ON
1 SWITCH-ON INHIBIT
2 READY TO BE SWITCHED
ON
3 SWITCHED ON
4 OPERATION_ENABLED
Color
green Logic module voltage is OK.
yellow Axis is standing still (speed = 0)
yellow A voltage of 24 V is applied to the input of
the positive limit switch (LIMIT+).
yellow A voltage of 24 V is applied to the input of
the negative limit switch (LIMIT-).
State
Initialization of amplifier functions
Initialization completed. Safe state
achieved after initialization and
acknowledgement of errors.
The drive controller can be switched
on.
Drive controller has been disabled by
software command.
The drive controller can be switched
on.
DC link monitoring is activated.
The drive controller is enabled.
Meaning
Meaning
71