Enable Input Without Option -S1; (Safe Torque Off) - Jetter JetMove D203 User Manual

JetMove D203
7.7.1
Specification of terminal X73 / X83
•
•
•
•
*) is connected to the ground of the controller.
For connections see "Connection Diagrams", page 87.
Jetter AG

Enable Input without Option -S1

(Safe Torque Off)

2-pin screw clamping terminal (type MC 1.5/ 2-ST-3.81)
Cross-sectional area of connecting cable: 0.14 ... 1.5 mm
with bootlace ferrules in a plastic sleeve: 0.25 ... 0.5 mm
Bladed screw-driver: 0.4 x 2.5 mm
Stud torque for the screw clamping terminal: 0.22 Nm (1.95 lbf-inch)
Terminals Signal
X73/X83
ENABLE Hardware
enable for
the power
supply of the
motor
(Input)
0 V Common
ground
7.7 Digital Inputs, Logic Power Supply
Enable Inputs
Description
• At this input, a high
signal is necessary for
power supply of the
motor. This signal must
have been applied
before carrying out the
software enable.
• A low signal de-
energizes the motor
immediately.
2
(AWG 26 - AWG 16)
2
(AWG 24 ... AWG 20)
Specification
• DC 24 V
• 5 mA max.
• Operating
point: < 6 V low,
> 15 V high
*)
Ground for the
enable inputs
73