Option -Jc24X; Electrical Installation - Jetter JetMove D203 User Manual

JetMove D203-JC24X
12
12.1
Jetter AG

Option -JC24X

Electrical Installation

NOTICE
Make sure that the connecting cables are correctly wired when
installing the integrated controller -JC24X.
Reverse polarity of the digital inputs and outputs leads to damages of
the integrated controller -JC24X.
You can use our prefabricated programming, HMI and connecting
cables for the Jetter system bus. For more information refer to chapter
12.10.1 "Overview of interface cables", page 119.
For installation according to EMC, the chapter 1.4 "Instructions on
EMC", page 20 must be read and followed.
Connect a HMI and your integrated controller using the interface cable
JN-DK via the SER2 interface.
Connect the -JC24X integrated controller to your computer using the
JN-PK programming cable via an SER1 or SER2 interface or via
Ethernet.
For the Ethernet connection, set the required IP address using the
address switches.
Install JetSym on your computer.
Launch JetSym and set the communication parameters.
Energize the JM-D203-JC240 and transmit a JetSym program from
your computer to the integrated controller -JC24X.
Check the controller for proper functioning.
12.1 Electrical Installation
93