Table of Contents
Advertisement
JetMove 203-230
7.4
7.4.1
Specification of the connector for terminal X61 (ENCODER)
•
•
Specification of HIPERFACE cable
•
•
•
•
•
•
7.4.2
Jetter AG
HIPERFACE Connection
Specification
9-pin male SUB-D connector
Metallised enclosure
Cable size: 4 * 2 * 0.14 mm² + 2 * 0.5 mm²
2 * 0.5 mm² must be used for power supply and GND
Twisted-pair cables shielded with the all-over shield must be used; the signal lines
must also be twisted in pairs:
Sine + and reference sine
Cosine + and reference cosine
DATA - and DATA +
0 V and power supply
The shield must be connected to the connector housings on both ends of the
cable with the greatest possible surface area.
Material: Copper
Temperature class: 60 °C
Maximum cable length: 50 m
HIPERFACE cable with mating connector
Note!
The resolver respectively HIPERFACE mating connector of the synchronous
servo motor series JL and JK can be ordered from Jetter AG by supplying the
following particulars:
Article # 15100069
The complete HIPERFACE cable between the servo amplifier series
JetMove 2xx and the synchronous servo motor series JL and JK can be ordered
from Jetter AG..
It can be ordered by supplying the following cable confection number:
Cable confection # 723
Resolver / HIPERFACE
For the servo amplifier series JetMove 2xx
7.4 HIPERFACE Connection
55
Advertisement
Table of Contents
