Hiperface Connection; Specification; Hiperface Cable With Mating Connector - Jetter JM-206-230 User Manual

7 Description of Connections
7.4
7.4.1
Specification of Mating Connector X61 (ENCODER)
•
•
HIPERFACE Cable Specification
•
•
•
•
•
•
•
7.4.2
60

HIPERFACE Connection

Specification

9-pin male SUB-D connector
Metallized enclosure
Cable size: 4 * 2 * 0.14 mm² + 2 * 0.5 mm² (AWG 26(8) + AWG 20(2))
2 * 0.5 mm² (AWG 20(2)) must be used for the power supply unit and for GND.
The cables have to be twisted in pairs and included in an overall shielding.
The following signal lines have to be twisted in pairs:
Sine + and reference sine
Cosine + and reference cosine
DATA - and DATA +
0 V and power supply
The shield must be connected to the connector housings on both ends of the
cable with the greatest possible surface area.
Material: Copper
Temperature class: 60 °C
Maximum cable length: 50 m
HIPERFACE Cable with Mating
Connector
Note!
The resolver respectively HIPERFACE mating connector of the Jetter motor
series JL, JK and JH can be ordered from Jetter AG by supplying the following
particulars:
Item # 15100069
The complete HIPERFACE cable connecting the servo amplifier series
JetMove 2xx and the Jetter motor series JL, JK and JH can be obtained from
Jetter AG. It can be ordered by submitting the following cable specifications and
the respective cable length in cm:
KAY_0723-xxxx
Resolver / HIPERFACE
For the servo amplifier series JetMove 2xx
Jetter AG