Installing the camera
1. Route the cables through the opening in the mounting shelf and connect them to the camera.
2. Place the camera on the mount.
3. Attach the camera to the mount using the mounting screw supplied with the camera.
Image for illustration only; not to scale. Camera and mount details may differ.
About ceiling-mounted cameras
If you use an inverted mount, set the camera's Image Flip mode ON for inverted operation. This orients
the video image correctly and sets the tilt motors to respond appropriately to tilt up and down commands
from the remote, web interface, and connected control devices. This control is available to the
administrator on the web interface's System page.
Installation Guide for the RoboSHOT 30E-M PTZ Camera
7