Table of Contents
Advertisement
Installation Guide for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera
Functional Check
Before you install the camera, you may want to verify functionality.
1. Connect the camera in its minimum functional configuration.
If not powered by a OneLINK device, the camera can be connected to an HDBaseT-capable
third-party control device through a PoE++ power injector (not provided). Connection details
vary depending on the equipment used in your installation.
2. Connect the camera's ribbon cable to the board on the trim ring.
3. Connect power. The camera moves, the indicator light turns blue, and video is available on the
connected display.
4. If the camera turns on and sends video, continue with the installation. Otherwise, double-check the
connections. Contact Vaddio technical support if the issue persists.
Camera powered by OneLINK HDMI
Camera Powered by OneLINK Bridge
Status Light
The light in the camera's trim ring indicates its current state, unless it has been configured to remain off.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off. When the lens is visible, the camera is on and sending video.
Blue: Ready/normal operation
n
Red: On-air tally (pro AV color scheme)
n
Purple: In standby mode or booting
n
Yellow: Firmware update in progress – overrides status light configuration
n
The pro AV color scheme is the default for this camera.
4
Advertisement
Table of Contents
