Advertisement
Status Lights
The lights in the camera's head indicate its current state.
Purple – Initializing
n
White – Active
n
Blinking red – Video is muted
n
Yellow – Firmware update is in progress
n
n
Blinking cyan – Remote pairing mode
n
Blinking blue – Pairing error
Caution
Do not remove power or reset the camera while the status lights are yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
By default, the status lights on Vaddio cameras are active during normal operation; however, they can be
configured to remain off even when the camera is sending video.
Next Steps
The camera is now ready to configure and use. This information is available in the Complete Manual for
the IntelliSHOT-M Auto-Tracking Camera.
Operation, Storage, and Care
For smears or smudges on the product, wipe with a clean, soft cloth. Use a lens cleaner on the lens. Do
not use any abrasive chemicals.
Keep this device away from food and liquids.
Do not operate or store the device under any of the following conditions:
Temperatures above 104° F (40° C) or below 32° F (0° C)
n
High humidity, condensing or wet environments
n
n
Inclement weather
n
Severe vibration
Dry environments with an excess of static discharge
n
Do not attempt to take this product apart. There are no user-serviceable components inside.
Vaddio is a brand of Legrand AV Inc.·
Fax +1.763.971.4464 · Email av.vaddio.support@legrand.com·
Vaddio is a registered trademark of Legrand AV Inc. All other brand names or marks are used for
identification purposes and are trademarks of their respective owners. All patents are protected under
existing designations. Other patents pending.
©2022 Legrand AV Inc.
Installation Guide for the IntelliSHOT-M Auto-Tracking Camera
www.legrandav.com
· Phone 800.572.2011 / +1.763.971.4400 ·
Advertisement
