How To Operate The Dispenser; How To Dispense Lng - Bennett Natural Gas Series Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

How to Dispense LNG

To dispense LNG, follow this procedure:

NOTE: Ensure that the dispenser is authorized by

the console.

1. The Card Reader Display (see figure D-1) will ask if

the customer has been trained. If "NO" is selected

instructions will be displayed. If "YES is selected

proceed to step two.

2. Remove the Vent Hose from the holder (see figure

D-2) and attach it to the vent adaptor on the

vehicle's tank.

3. Remove the nozzle from the holder (see figure D-2)

and attach it to the fill adaptor on the vehicle's tank.

4. Select the product select button (see figure D-1).

5. The "Sale$" Display and "DGE" Display will reset

with 8s and 0s.

6. At this point the dispenser will begin its recirculation

process.

7. Once the recirculation is complete the dispenser will

begin to fill the vehicle's tanks.

8. Once the tank is full the dispenser will go into a

Paused State.

9. If the vehicle has two tanks the customer removes

both hoses and installs them into the adaptors for

the other tank. If the vehicle only has one tank the

customer disconnects the hoses and hangs them up

in the

holder (see figure D-2), ending

transaction.

10. Once the second tank is hooked up the customer

presses the Pause / Resume button near the

Product Select Button (see figure D-1) to fill the

second tank.

11. Once the second tank is full the dispenser will return

to a Paused State.

12. At this time the customer will remove both hoses

and hang them up in the holder (see figure D-2),

ending the transaction.