Mode Switch Setting - Mitsubishi Electric AnyWire ASLINK User Manual

MODE switch setting

Use the MODE switch located on the front of the NZ2AW1GNAL to set the number of transmission points and the operation
mode of AnyWireASLINK.
The MODE switch setting is enabled when the NZ2AW1GNAL is in the power-on state, so set it while the power is off.
When operating the MODE switch, use a flathead screwdriver with a tip width of 0.8mm or less.
Setting method
Use MODE switch 1 to MODE switch 12 to set each function.
All switch positions are set to off when the product is shipped.
Switch name
MODE switch 1
MODE switch 2
MODE switch 3 to MODE switch 5
MODE switch 6 to MODE switch 8
MODE switch 9 to MODE switch 12
Setting item Setting
Operation mode Turn it off during normal operation.
Turn it on when performing unit tests. ( Page 113 Unit Test)
Number of AnyWireASLINK Turn it on when using MODE switch 3 to MODE switch 8 to set the number of
transmission points setting points.
Turn it off when setting the number of points using an engineering tool.
Number of AnyWireASLINK bit Set the number of AnyWireASLINK bit points. ( Page 26 Number of
points AnyWireASLINK bit points setting)
Number of AnyWireASLINK Set the number of AnyWireASLINK word points. ( Page 26 Number of
word points AnyWireASLINK word points setting)
Use prohibited Fix them to off.
5 INSTALLATION AND WIRING
5.1 Setting Switch
5
25