Response Delay Time - Mitsubishi Electric AnyWire ASLINK User Manual

Response delay time

The following shows the response delay time of input and output.
Input response delay time
The figure below shows the time between a signal input to the slave module and the remote device turning on/off.
The input response delay time is the total of  to  in the following figure.
Input
(1)
(2)
(3)
(1) Input device
(2) AnyWireASLINK system
(3) CC-Link IE TSN
No. Description

Input response time on the slave module
 Transmission time

Processing time of the NZ2AW1GNAL
Ò
Ó
Required time
Refer to the manual of the slave module connected to the system (manufactured by Anywire
Corporation).
• Bit data: Bit transmission cycle time  2
• Word data: Word transmission cycle time
The transmission cycle time varies depending on the specified number of bit data points and the
specified number of word data points.
Page 178 Transmission cycle time formula
1.0ms
Ô
Output to CC-Link IE TSN side
APPX
Appendix 5 Processing Time
A
181