Wiring method
This section describes the wiring to the transmission cable terminal block of the NZ2AW1GNAL.
Wiring to the transmission cable terminal block
■Connecting a cable
Insert a cable with a bar solderless terminal into a wire insertion opening and fully push the cable. Then, pull the cable slightly
to check that it is clamped securely.
■Disconnecting a cable
Hold down the open/close button of a cable to disconnect with a flathead screwdriver. Pull out the cable with the open/close
button held down.
5
5 INSTALLATION AND WIRING
33
5.5 Wiring to a Transmission Cable Terminal Block of the AnyWireASLINK