Parameter setting
Setting in the master station
Connect the engineering tool to the CPU module on the master station and set parameters.
1.
Set the CPU module as follows.
[Project] [New]
2.
In "CPU Parameters", set "Link Direct Device Setting" to "Extended Mode (iQ-R Series Mode)".
[CPU parameters] [Memory/Device Setting] [Link Direct Device Setting] [Link Direct Device Setting]
When using the engineering tool to write the module parameters of RJ71GN11-T2 to the CPU module, set
"Link Direct Device Setting" to "Extended Mode (iQ-R Series Mode)".
When "Link Direct Device Setting" is "Q Series Compatible Mode", "Write to PLC" cannot be executed.
3.
Set the master/local module as follows.
[Navigation window] [Parameter] [Module Information] right-click [Add New Module]
8 PROGRAMMING
86
8.2 Program Example