Appendix 5 Processing Time - Mitsubishi Electric AnyWire ASLINK User Manual

Appendix 5
This section describes the processing time related to the transmission of AnyWireASLINK.
The following shows the processing time of when using the NZ2AW1GNAL.
The transmission delay time is the total of (1) to (5) below.
CC-Link IE TSN
RCPU
master/local module
(1) (1)
No. Description
(1) Sequence scan
(2) CC-Link IE TSN communication cycle
interval
(3) Processing time of the NZ2AW1GNAL
(4) AnyWireASLINK transmission cycle
time
(5) AnyWireASLINK slave module
processing time
APPX
170

Appendix 5 Processing Time

Processing Time
(2)
Master Slave
station station
CC-Link IE TSN
Required time
Since the sequence scan depends on the performance of the CPU module, refer to the user's
manual for the CPU module used.
For the calculation formula of the communication cycle interval, refer to the following.
 User's manual for the master station used
1.5ms
The transmission cycle time varies depending on the specified number of bit data points and the
specified number of word data points.
Page 171 Transmission cycle time
Refer to the slave module product guide.
NZ2AW1GNAL
(3)
Master
station
AnyWireASLINK
AnyWireASLINK
slave module
(5)
(4)
Slave
station
Sensor switch
or others