Access Protocol; Vsip - Kedacom IPC4X2 Series User Manual

HD Mini Dome Camera







4.2 Access Protocol

Go to Settings > Network > Access Protocol, and access the camera to different platforms by
configuring different access protocols.
4.2.1

VSIP

The web client supports accessing to back-end platform through VSIP protocol.
Configuration steps:
Note: Multicast is a method of data packet transmission. The source host can send
the data packets to every host in the group by sending a datagram only. It
also depends on the group relationship maintenance and selection by the
router.
Stream Type: the stream to be sent, the default being "Main Stream".
Media Type: the media type of the stream to be sent, the default being "Video".
Multicast Address: the address to send the stream, fill it according to the actual
conditions.
Multicast Port: the multicast port of the multicast address, the default being 61000,
ranging 1 ~ 65535.
Send Mode: options include "Passive" and "Initiative". Under "Initiative" mode, if the
multicast addres is normal and valid, the default setting is to send stream to this
multicast address; under "Passive" mode, only when receiving the request of
multicast can the system send stream to the multicast address. If the address is set
0.0.0.0, the system will send stream to 239.2.2.2 by default.
TTL: Time to Live, ranging 0~255.
Note: TTL means the maximum number of network segments allowed to pass
through IP data packet before it is discarded by the router. It is used to avoid
endless loop of sending and receiving the data packet in the network so as to
save network resources.
Picture 4-3 Multicast
24
User Manual