Network Test; Lifetime - Kedacom IPC4X2 Series User Manual

HD Mini Dome Camera
8.6.2

Network Test

Go to Settings > System > System Maintenance > Network Test, and test the network connectivity
between the device and the destination address.


8.6.3

Lifetime

Go to Settings > System > System Maintenance > Lifetime to view the running status of the
device.

Working Mode: configure the stream working mode. It takes effect after reboot.
 Audio Noise Reduction: configure "Collect Audio Stream" and "Decode Audio Stream".
Options including "Close", "Low", "Middle" and "High"; enabling this function will occupy
some system resources.
 Alarm: configure "Minimum Alarming Interval", value range being 1~60 s.

Transparent Serial Data Report: After enabling this function, the system will report
exceptions of serial port (the serial port of PTZ camera is connected to peripheral device but
the dynamic plug-in is not enabled) to the platform.
Enter an IP address in "Destination Address" and click "ping". The test result will show on the list
below;
Enter an IP address in "Destination Address" and click "trace". The test result will show the
routing entries visiting the destination address. It is used to test the network routing information
between the device and the destination address.
Picture 8-16 Network test- ping
Picture 8-17 Network test- trace
106
User Manual