Configuration Selections For Hssi And V.35 Interfaces; Table 3-1. Hssi And V.35 Configuration Selections - ADTRAN OSU 300 User Manual

Configuration Selections for HSSI and V.35 Interfaces

The configuration selections listed in Table 3-1 are available for
HSSI and V.35 interfaces. Additional selections listed in Table 3-2
on page 3-6 apply only to V.35 interfaces.
s
S
ELECTION
I T
NTERFACE YPE
P S
ORT TATUS
I
NACTIVE
A
CTIVE
W
AITING
E
RROR
N I
OT NSTALLED
P S
ORT TATE
N 75 B
X K LOCKS
P B
ORT ANDWIDTH
61200663L1-1

Table 3-1. HSSI and V.35 Configuration Selections

D
ESCRIPTION
This read-only status field shows the interface type of the selected port
(HSSI or V.35).
This read-only status field displays one of the following messages to
show the port status of the selected port:
E N I
, or
RROR OT NSTALLED
The port is installed, but idle. Activate a port through the
field of this menu.
The port has been configured and is passing data.
The port has been configured and is waiting for the DTE to issue the
appropriate handshaking signals.
• For the HSSI interface, the terminal equipment available (TA)
signal must be asserted by the DTE.
• For V.35, DTR is required if the TR field in this menu is set to
W O
; otherwise, DTR is ignored.
HEN FF
An error condition such as loss of transmit clock has occurred.
An interface card is not installed in the selected port. If a port is not
installed, the remainder of the
appear.
If a port is installed but not currently in use, set to
E
to activate an installed port.
NABLED
This field determines the amount of bandwidth allocated to the selected
port. For a HSSI interface, the selections are from 1-588 (yielding a
bandwidth of 75.2 kbps to 44.2 Mbps). For a V.35 interface, the
selections are from 1-140 (yielding a bandwidth of 75.2 kbps to 10.5
Mbps). Changes to this field do not take effect until
is selected.
This read-only status field shows the amount of bandwidth that will be
available if the selection made in the
OSU 300 User Manual
Chapter 3. Configuration
I
,
NACTIVE
.
P C
ORT ONFIGURATION
D
N 75 B
X K LOCKS
A W
, ,
CTIVE AITING
P S
ORT TATE
I
DLE
menu does not
. Set to
ISABLED
A S
PPLY ETTINGS
field is applied.
3-5