State Logic Cpus; Features Of State Logic Cpus - GE 90-30 PLC Series Installation And Hardware Manual

9

State Logic CPUs

Five models of State Logic CPUs are available that support State Logic programming. Three of
these CPUs are of the embedded baseplate type, and two are modular CPUs. Data sheets for these
modules are located at the back of this chapter. The available State Logic CPUs for the Series 90-
30 PLC are:

Features of State Logic CPUs

9-8 Series 90-30 PLC Installation and Hardware Manual – August 2002
IC693CSE311 and IC693CSE313, both are 5-slot embedded CPU (CPU is built-in)
baseplates.
IC693CSE323, 0-slot embedded CPU baseplate.
IC693CSE331 and IC693CSE340, single-slot CPU modules (can be installed in standard
IC693CHS397 5-slot CPU baseplate, or standard IC693CHS39
Support State Logic programming
Support Floating Point calculations
Support Clock/Calendar functions (CSE33 and 340 are battery backed)
Support discrete and analog overrides
Programmed by State Logic software products
Provide from 0K to 98K Bytes of program memory depending on model
Program memory is battery backed
Control two Status LEDs on the power supply
Software configuration (no DIP switches or jumpers to set)
Serial port on power supply used as a programming port, a simple ASCII interface, or a CCM
port
Password controlled access
Support Series 90-30 I/O products
Alarm Processor Function for module diagnostics
Simulation mode
EPROM and EEPROM program memory
Store histogram of State Changes
0-slot CPU baseplate).
GFK-0356Q