Battery; Cable Information; Hardware Specifications; State Logic Processor (Slp) Documentation - GE 90-30 PLC Series Installation And Hardware Manual

Battery

A lithium battery (IC697ACC30 ) is installed as shown in the previous figure. This battery
maintains user memory when power is removed. Be sure to install a new battery before removing
the old battery (two connectors are provided). Indication of a low battery is provided through the
ECLiPS programming system software and Logicmaster 90-30 software.

Cable Information

Cable IC693CBL305 can be used in applications that require use of both SLP serial ports. This is a
Wye-type cable that breaks out the Port and Port 2 connections on the module's single connector
to two individual connectors. A data sheet for this cable can be found in the "Cables" chapter of
this manual. (Additional SLP cable information is found in publication GFK-0726 - see
"Documentation" section.) This cable is not required for applications that use only one SLP port.

Hardware Specifications

Battery:
Internal Power Consumption
Serial Ports:

State Logic Processor (SLP) Documentation

Please refer to the following publications for more State Logic Processor information.
Series 90-30 PLC State Logic Processor User's Guide
Series 90-30 PLC ECLiPS User's Manual
Series 90-30 PLC OnTOP User's Guide
OnTOP for Series 90-30 Online Troubleshooting and Operator Program User's
Manual
Series 90-30 State Logic Control System User's Manual
GFK-0356Q Chapter 9 State Logic Products
Shelf Life
Memory Retention
5 years at 20°C (68°F)
6 months nominal without applied power
400 mA from 5V bus on backplane
Two RS-232/422/485 compatible
Title
9
Part Number
GFK-0726
GFK-0732
GFK-0747
GFK-0750
GFK- 056
9-7