GE 90-30 PLC Series Installation And Hardware Manual page 394

Catalog Number to Publication Cross-Reference
Appendix
G
Manuals are not shipped with many of the Series 90-30 products; they must be ordered separately.
This appendix can help you identify the correct documentation to order and use. Products are arranged
in this appendix by categories such as Analog I/O Modules, Baseplates, Communications Modules,
etc. The category headings are listed in alphabetical order. Modules that share common
documentation are grouped under a generic catalog number, such as IC693ALGxxx for the Analog I/O
modules.
Note that you may not need every publication listed for a particular product. Your need for some of
the publications depends on your application. For example, if you intend to use Logicmaster
programming software to configure and program your PLC, you will not need manuals for the other
programming software products or the Hand Held Programmer. Or, if you are going to program your
Programmable Coprocessor module using the C computer language, you will not need the MegaBasic
language manual. A list of publication titles is included at the end of this data sheet.
Abbreviations Used
GFK-0356Q
HHP — Hand-Held Programmer
LM90 — Logicmaster, a DOS-based programming and configuration software
SFC — Sequential Function Chart
G-1