Cpu360; Catalog Number Ic693Cpu360 - GE 90-30 PLC Series Installation And Hardware Manual

CPU360

CPU Type
Total Baseplates per System
Load Required from Power Supply
Processor Speed
Processor Type
Operating Temperature
Typical Scan Rate
User Program Memory (maximum)
Discrete Input Points - %I
Discrete Output Points - %Q
Discrete Global Memory - %G
Internal Coils - %M
Output (Temporary) Coils - %T
System Status References - %S
Register Memory - %R
Analog Inputs - %AI
Analog Outputs - %AQ
System Registers for reference table
(
viewing only; cannot be referenced in
logic program)
Timers/Counters
Shift Registers
Built-in Serial Ports
Communications
Override
Battery Backed Clock
Interrupts
Type of Memory Storage
PCM/CCM Compatibility
Floating Point Math Support
GFK-0356Q Chapter 5 CPUs

Catalog Number IC693CPU360

Single slot CPU module
8 (CPU baseplate + 7 expansion and/or remote)
670 milliamps from +5 VDC supply
25 MegaHertz
80386EX
0 to 60 degrees C (32 to 140 degrees F) ambient
0.22 milliseconds per 1K of logic (boolean contacts)
Starting with firmware Release 9.0, 240K Bytes. Note: Actual
size of available user program memory depends on the
amounts configured for the %R, %AI, and %AQ configurable
word memory types (see below). For firmware prior to
Release 9.0, fixed size is 80K bytes.
2,048
2,048
1,280 bits
4,096 bits
256 bits
128 bits (%S, %SA, %SB, %SC - 32 bits each)
Starting with firmware Release 9.0, configurable in 128 word
increments from 128 to 16,384 words with Logicmaster and
from 128 to 32,640 words with Control version 2.2. For
firmware prior to Release 9.0, fixed size is 9,999 words.
Starting with firmware Release 9.0, configurable in 128 word
increments from 128 to 16,384 words with Logicmaster and
from 128 to 32,640 words with Control version 2.2. For
firmware prior to Release 9.0, fixed size is 9,999 words.
Starting with firmware Release 9.0, configurable in 128 word
increments from 128 to 16,384 words with Logicmaster and
from 128 to 32,640 words with Control version 2.2. For
firmware prior to Release 9.0, fixed size is 9,999 words.
28 words (%SR)
>2,000
Yes
1 (uses connector on PLC power supply). Supports SNP slave
and SNP-X slave protocols. Requires CMM module for
SNP/SNP-X master, CCM, or RTU slave protocol support;
PCM module for RTU master support.
LAN - Supports multidrop. Also supports Ethernet, FIP,
Profibus, GBC, GCM, and GCM+ option modules.
Yes
Yes
Yes
RAM and Flash
Yes
Yes, firmware-based in firmware Release 9.0 and later.
5
PS
PORT
CPU 360
ON
OFF
5-37