GE 90-30 PLC Series Installation And Hardware Manual page 369

IC693PRG300 Hand-Held Programmer (HHP)
Some models of the Series 90-30 PLC can be programmed with the GE Hand-Held
Programmer (HHP). The HHP uses the Statement List Language. With the HHP, you can develop,
debug, and monitor logic programs, monitor data tables, and configure PLC and I/O parameters.
The HHP connects to the CPU serial port through a 15-pin D-type connector on the Series 90-30
PLC power supply in the CPU baseplate. The physical connection is through a 6-foot (2-meters)
long cable (IC693CBL303). This cable also provides power connections to the HHP, and provides
a signal that tells the PLC that an HHP is attached. The HHP can be connected or disconnected
while the PLC is powered-up. The HHP does not require communications parameter configuration
in order to communicate with a PLC. This makes it useful for troubleshooting a communications
problem between a PC and the PLC.
Figure 11-5. Hand-Held Programmer for the Series 90-30 PLC
GFK-0356Q Chapter 11 Programmer Hardware Products
The user logic program in Series 90-30 CPU numbers 350 and above cannot be
viewed or edited with the Hand-Held Programmer. You must use
Logicmaster 90-30, Control, VersaPro, or Logic Developer-PLC programming
software with those CPUs.
SERIES 90-30
PROGRAMMABLE
CONTROLLER
HAND HELD PROGRAMMER
LD
OUTM
D E
AND
A B
I
A I
7
4
1
0
Programmer Hardware Products
Note
OUT SETM RSTM TMR
MODE
SET
RST ONDTR
F
OR
UPCTR
BLK RUN
NOT
DNCTR
C
Q M G
AQ FUNC
DEL
T S
#
8 9 R
SRCH
5 6
WRITE INS
READ
2 3
VRFY
HEX ENT
CLR
DEC
SERIAL PORT CONNECTOR
TO CPU SERIAL PORT
11
a43052
SLOT
FOR
MEMORY
CARD
11-5