Temporary Neutral Stud; Adjustment; Adjusting The Hydro Control; Linkages - Toro 30433 Operator's Manual

Figure 47
1. Actuating tab
2. 1/8 to 1/4 inch (3 to 6 mm)
space
12. To adjust the switch location, loosen the two
neutral bracket screws holding the switch plate
to the frame (Figure 47).
13. Adjust the switch up or down to obtain an 1/8
to 1/4 inch (3 to 6 mm) space (Figure 47).
14. Tighten the two neutral bracket screws holding
the switch plate (Figure 47).

Temporary Neutral Stud

Adjustment

Note: Perform the following procedures on both
the left and right sides.
1. Move the left and right hand neutral lock
latches to the unlatched position.
2. Move the speed control lever to the neutral
position (Figure 48).
3. Loosen the nut against the yoke Figure 48).
4. Adjust the length of the neutral stud and yoke
assembly so the clevis pin does not contact
the back of the slot in the control arm bracket
Figure 48).
5. Tighten the nut against the yoke Figure 48).
3. Safety switch
Figure 48
1. Neutral control linkage
2. Yoke
3. Neutral stud
4. Nut against yoke

Adjusting the Hydro Control

Linkages

Engine must be running so control linkage
adjustments can be performed. Contact
with moving parts or hot surfaces may cause
personal injury.
Keep hands, feet, face, clothing and other
body parts away from rotating parts, muffler
and other hot surfaces.
Mechanical or hydraulic jacks may fail to
support machine and cause a serious injury.
• Use jack stands when supporting
machine.
• Do not use hydraulic jacks.
Adjusting the Left Side Linkage
1. Disengage the PTO and set the parking brake.
2. Stop the engine and wait for all moving parts
to stop before leaving the operating position.
38
5. Slot in control arm bracket
6. Clevis pin
7. Clevis pin does not contact
the back of slot