Installing An Internal Sd Card - Dell EMC PowerEdge FC430 Owner's Manual

Related links
Safety instructions
Before working inside your system
After working inside your system
Troubleshooting an internal SD card

Installing an internal SD card

Installing an internal SD card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If applicable, remove the SD card.
NOTE: To use an SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
Steps
1 Locate the SD card connector on the internal dual SD module. Align the keyed end of the SD card into the slot and insert the card into
the slot
NOTE: The slot is keyed to ensure correct insertion of the card.
2 Press the card into the card slot to lock it into place.
Figure 19. Installing an internal SD card
1 SD card slot
68 Installing and removing sled components
2 SD card