Table of Contents
Advertisement
Steps
1
Disconnect the battery cable connected to the PERC card.
2
Pull the PERC card out of the connector on the internal PERC riser.
Figure 31. Removing the PERC card from the internal PERC riser
Next step
Replace the PERC card into the PERC riser.
Installing PERC card into the internal PERC riser
Prerequisites
1
Follow the safety guidelines listed in
2
Power off the system and all attached peripherals.
3
Disconnect the system from the electrical outlet, and disconnect the peripherals.
4
Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5
Open the drive
bays, remove
6
Remove the
power supply
7
Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
8
Remove the system
cover.
9
Remove the air shroud.
10
If installed,
remove the rear drive
Safety
instructions.
all
drives, and then
close the drive bays.
units.
cage.
Installing and removing system components
59
Advertisement
Table of Contents
