Xilinx EZTag User Manual page 62

Error Messages
Xilinx customer service should be contacted.
When the Xchecker reconfiguration file xckjtag.sys is not found or
loaded correctly the above messages are displayed. Check that your
XACT path includes the release "data" directory and that the file
"xckjtag.sys" exists in it. Also, check the integrity of the
connections to the xchecker cable both at the serial port and to the
target system.
This is the warning message issued when data protect is enabled. It
is displayed with each operation addressing this device.
This is the warning message issued when data security is enabled. It
is displayed with each operation addressing this device.
These messages are displayed when the software identifies that the
specified operation is targetting an improper device. Check that the
specified part exists in the boundary-scan chain that you declared in
your "part" command. A new "part" command will override the
previously specified one. The current "part" database can be
displayed by typing "part" followed by a carriage return.
A-10
Error 1036: Xchecker configuration file for boundary-
scan TAP driver not found. Check XACT path setting and
locate file named 'xckjtag.sys'.
Warning 1037: Data protection is enabled in instance
string (NOTE: device programming contents cannot be
altered).
Warning 1038: Data security is enabled in instance
string (NOTE: device programming contents cannot be
read).
Error 1039: The device string is not a Xilinx part
(IDCODE: string )
Error 1040: The device string is not a XC9500 part
(IDCODE: string ) Please verify the specification of
the order of the parts in the boundary-scan chain.
Error 1041: The device string is not an XC95108 part
(IDCODE: string ). Please verify the specification of
the order of the parts in the boundary-scan chain.
Error 1042: The device string is not a currently
supported XC9500 part (IDCODE: string ) Please verify
the specification of the order of the parts in the
boundary-scan chain.
Xilinx Development System